Janome myLock 134D, Руководство по обслуживанию

Страница: 15 / 39

NEEDLE BAR HEIGHT
The distance between the tip of needle on the right and the surface of needle plate (D) should
be 11.2 to 11.6 mm (7/16 to 29/64) when the needle bar is at the highest position.
TO ADJUST
1. Remove the face plate (Refer to page 6) and the presser foot.
2. Turn the hand wheel toward you with your hand to set the needle bar (B) at the highest
position.
3. Loosen the set screw (A) and adjust the height by using the part (C) of the gauge No.
8289. Tighten the set screw (A) after the adjustment is done.
Note: Be careful not to turn the needle bar (B).
4. Turn the hand wheel toward you one cycle, and recheck the needle bar height.
Check the clearance between needles and lower looper / needle guards/fixed needle
guard/upper looper. (Refer to pages 19, 20, 21 & 26.)
5. Attach the face plate (Refer to page 6) and presser foot.
13
www.promelectroavtomat.ru