Janome AT2000D, Инструкция

Страница: 30 / 65

27
Using a standard thread
z
Pass the thread up to the looper thread guide (in front
of the looper threader hole).
q
Looper thread
x
Prepare 12˝ (30 cm) of a standard thread and tie it 5
cm from the end of the looper thread as shown.
w
Standard thread
e
Knot
r
5 cm
t
c
y
v
u
i
b
Figure A
e
c
t
,
q
m
q
w
e
z x
q
w
e
r
x
o
n
q
z
q
NOTE:
when tying the standard thread to the looper thread,
tie a knot as small as possible and cut any excess
standar thread.
c
Set the looper threader switch lever to “THREADING”
position.
t
Looper threader switch lever
v
Turn the handwheel toward you slowly until it clicks.
This locks handwheel in place.
y
Handwheel
b
Using the tweezers, insert approximately 1˝ (2 cm) of
the standard thread into the threading hole.
u
Tweezers
i
Looper threader hole
n
Raise the looper threader lever until it clicks into
place.
Lower the looper threader lever until it knocks into
place.
o
Looper threader lever
m
Pull out approximately 4˝ (10 cm) of the standard
thread from the hole in the looper tip and trim it at the
knot.
* When the knot reaches the looper threader hole,
fold the loose end of the looper thread as illustrated
by figure A in procedure
b
.
,
Return the looper threader switch lever to the
“SEWING” position.
Replacing threaded looper thread
z
Cut the threaded looper thread between the thread
guide and the top cover thread guide.
q
Thread guide
w
Top cover thread guide
x
Set a new spool of looper thread.
Pass the new looper thread through the thread guide,
and tie it to the end of the threaded looper thread.
Tie a knot as small as possible.
e
Knot
c
Slowly pull the threaded looper thread out from the
hole of the looper tip until the knot comes out.