Janome 6260QC -, Руководство по обслуживанию

Страница: 17 / 35

Mechanical adjustment
Needle Bar Height
When the tip of the hook meets the left side of the needle in ascending travel of the needle from its left
and lowest position, the distance between the top of the needle eye and the tip of the hook should be in
the range of 1.6 to 2.0 mm.
1. Select the straight stitch “ “ and set the stitch width at “7.0”.
2. Remove the needle plate (A) and bobbin holder (B).
3. Turn the handwheel until the tip of the hook point meets with the right side of the needle.
4. Remove the face cover and loosen the setscrew (C).
5. Adjust the needle bar height by moving the needle bar up or down.
6. Tighten the setscrew (C).
7. Attach the face cover, bobbin case and needle plate.
Note: Be sure that the groove on the needle bar is facing right in the front.
Setscrew (C)
Needle plate (A)
Needle plate setscrew
Hook (B)
Bobbin holder
Needle (#14)
Hook race
1.8 mm + - 0.2 mm
Hook point right side of needle
Groove
Top of needle eye
15