JPC 100-WEB
www.janitza.de
22
9. 1
Master devices
The JPC 100-WEB allows you to manage
up to four master devices. The first position
is reserved for the JPC 100-WEB (for more
information, see „9. 1. 1 Integrating a new
master device“).
To configure a device that is already integrat-
ed, select it on the start page before opening
the configuration.
Different configuration options are available
here depending on the type of the selected
device.
Use this drop-down menu to select which device
you are configuring in the JPC 100-WEB. The first
list entry of the master devices is reserved for the
JPC 100-WEB as the master.
The device name determines the name under
which the device is listed in the JPC 100-WEB
user interface. The configuration on the device
itself is not affected by this.
This checkbox controls the visibility of the device
on the start page.
When you integrate measurement devices using
Modbus RTU, the master device (JPC 100-WEB)
and slave devices must have the same baud rate.
(The respective user information describes how
to determine the baud rate of the respective slave
devices.)
If you integrate master devices using Modbus TCP,
you must know the Modbus ID and the TCP/IP ad-
dress of the device. (Information on how to deter-
mine this data can be found in the corresponding
usage information.)
Use these checkboxes to specify whether and
which values of the master device are displayed on
the start page. The values available here depend
on which measured values are supplied by the
device.
For devices with a device homepage (e.g. UMG
509/512/604/605), you can optionally display a
button in the measured value details which leads
to the device homepage.
Use the Actions for all UMGs button to reset ener-
gy meters and minimum/maximum current mea-
surement values for all UMGs and to transfer the
current configuration to all UMGs
Save your changes using the
Save
button.
Use this button to open the alarm configuration for
this device.
