Page 26
CAUTION
Before attempting to operate refer to page 15 - Pool Water Preparation. Also, do not adjust Chlorine
production above 00% until it is certain that salt has been dissolved in pool. Operating without salt
will damage Electrolytic Cell.
Beeper Control
Beeper operation and volume control can be adjusted.
To adjust volume control, press and hold the
TEMPERATURE
button
for 15 seconds. The system will beep once when pressed, once after 10
seconds and once after 15 seconds. Release the key after the third beep.
Press the
Salinity
button within 5 seconds to enter the temperature change
screen.
The system will display a ‘1’ followed by ‘F’ or ‘C’. Press the
TEMPERATURE
button to move to the second parameter screen. The
screen will display a 0, and the beeper volume will be fully reduced. The
system will occasionally show a ‘2’ to display the screen number.
Press the arrow button B to increase the volume and the arrow button
A to reduce the volume. The volume increments from 0 to 100 in 20
steps. After each press of the arrow buttons, the beeper will activate to
demonstrate the current volume level.
When the beeper volume has been adjusted to the desired setting, press
the
Salinity
button to con
fi
rm the new beeper volume setting. The change
will be stored in permanent memory.
If you do not wish to keep the change, wait 5 seconds, and the change
screen will ‘time out’ and return to normal operation without keeping
any changes to the system. Any changes made to the beeper volume will
NOT be saved if this occurs.
The
Boost
cycle is normally activated after 10 seconds. However, if the
key is held down until after the third beep at 15 seconds, the
Boost
mode
will not be changed.
5.3 Operation
Use of an external Pool Pump Timer is not required.
The AquaPure is designed to supply a suf
fi
cient
amount of chlorine to sanitize pool water on a daily basis. If the AquaPure is operated 24 hours a day at
100%, more chlorine would be generated than would be needed by most pools (1-3 PPM). The AquaPure
has its own internal timer which cycles the electrolytic cell on and off depending on what percent the
Chlorine Production is set. For instance, at 100% the cell works all the time. When set at 90%, the cell is
allowed to rest 10% of the time prolonging cell life. In order to
fi
ne tune the AquaPure to any size pool just
increase or decrease the Chlorine Production from 00% to 100%. (see “Apply Power” Section 5.4.2, page
25, steps 1-5 )
• Check Chlorine Level on a regular basis and adjust AquaPure accordingly.
Содержание AquaPure APURE700
Страница 2: ......
