Step13:
Turn on the acc ignition, link by Bluetooth a music source to the audio system
controller and verify that both speakers and the amplifier are functioning properly.
Step14A-Carmel:
Route the braided ground strap from the front master grounding post, back
under the left side body, to the rear grounding post, located next to but outside of the battery
and secure.
Step14B-Venice:
Route the braided ground strap from the right front master grounding post,
back under the right side body, to the rear grounding post, located next to but outside of the
battery and secure.
Step15A-Carmel:
Route the subwoofer wiring harness, starting from inside the left rear storage
compartment, down thru the circuit breaker access opening, down thru the grommet, and
forward along the body thru to the upper engine cowl location. (Follow the routing of the
ground strap)
Step15B-Venice:
Route the subwoofer wiring harness, starting from inside the right rear
storage compartment, down thru the circuit breaker access opening, down thru the grommet,
and forward along the body thru to the upper engine cowl location. (Follow the routing of the
ground strap)
Step16:
Plug the 4-pin plug on the sub wiring harness into the corresponding 4-pin plug on the
ROKKER amplifier wiring harness, at the upper engine cowl location.
Step17:
Disconnect the ground cable from the battery at this time and then connect the main
red power wire from the subwoofer harness, to the forward post on the circuit breaker box,
located inside the rear storage compartment.
