This is a full range class D amplifier and is spec’d at 100watts RMS per channel X2
channels, (200w total) driven continuous into a 2 ohm load @ 14.4vdc.
Amplifier mounts into the same location as the stock amp and connects to the on-
board Bluetooth powered audio controller.
Custom made plug-n-play wiring harnesses are included with this complete audio
kit, top quality heavy gauge power/ground wires are used for the fused battery
connection, along with all necessary mounting hardware & complete
installation/operation and tuning instructions.
Amplifier itself measures 6 1/2” X 4 ¾“ X 1 ¾”.
Installation Guide
Step1A-Carmel:
Remove the windshield, dash cover, complete front engine cowl, gauge/wire
loom cover, driver and passenger se
ats, driver’s side lower body trim section, rear center
wheel-well cover and left side rear finned assembly.
Step1B-Venice:
Remove the windshield, dash cover, complete front engine cowl, gauge/wire
loom cover, driver and passenger seats, passenger side lower body trim section, rear center
wheel-well cover, right side finned assembly and shock absorber.
Step2A-Carmel:
Remove both left and right inside kick-panel speakers.
Step2B-Venice:
Remove both left and right inside kick-panel speakers.
Note:
For Venice
Blackjack model WITHOUT factory speakers installed, locate speaker mounting holes/cutouts
already in the aluminum frame, behind the fabric panels, and cut out the fabric panels to allow
speaker installation.
Note:
For Venice Blackjack model WITHOUT the factory amplifier installed, you can skip steps 3
& 4.
Step3:
Remove the stock audio amplifier located under the left underside of dash and along
with it, the complete amplifier/speaker wiring harness.
Step4:
Locate the blue wire with plug on the au
dio amplifier harness and cut it off with 6” of
blue wire attached to the plug. (You will use this section of wire later during the installation)
Step5:
Position the ROKKER amplifier back up under the dash, in place of the stock unit to get a
reference on the new mounting location and to make sure that the amplifier mounting screws
are in the correct location for your particular model.
