Step8:
Now locate the 6” blue wire section with plug (that you cut off of the
stock amplifier
wiring harness) strip back the very end of the wire and crimp into the blue butt connector on
the new ROKKER amplifier wiring harness. Then plug the black connector on the end of the blue
wire, back into the corresponding wire harness location.
Note:
For Venice Blackjack model
WITHOUT factory audio system installed, splice the blue wire from the amplifier harness to any
good switchable 12v power source in the wiring harness.
Step09:
Position the ROKKER amplifier under the left side of the dash, (power cable pointing
forward) and connect all harness plugs to the amplifier. (It is advisable to tape the RCA plugs
together, so that they don’t wiggle loose over time)
Step10
: Slide the amplifier into the final mounting position, pushing the 3 studs up thru the
holes and then secure/tighten with the locking nuts. (insure that none of the wires are pinched
between the amplifier and inside upper dash panel)
Step11
: Push the supplied foam pads into the back of each speaker kick-panel opening to
provide acoustic dampening and cut or trim as necessary to get a good fit. (It is OK if the
speaker presses against the foam pads as the speakers are installed).
Step12:
Mount the left and right side ROKKER speakers by first plugging the wiring harness to
eac
h speaker and then tighten into place, with the M4X1” machine screws. IF the threaded
holes in the kick-
panels have previously been stripped out, then replace the M4X1” screws with
the self-tapping screws provided.
