IS297-22F
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 6/27
Align
Scrap
2x4’s
Installing Hanging Brackets:
• Place a hanging bracket over the just installed corner cap.
• Align narrow edge of hanging bracket with edge of fan housing, as shown below.
• Using the included
#3 Phillips Bit from Bag 1 (Tools)
and (6) #14-10 x 2”
Screws from
Bag 2 (Part 3)
, screw the corner to the panels.
• Repeat until all four hanging brackets have been installed.
5
Motor Installation:
NOTE:
2 person lift is recommended for handling of 105lb motor
• Using the pallet the fan came on, place the motor in the center between the pallet slats with
the shaft facing up.
• Place housing onto pallet curved side down.
• Use scrap wood 2x4’s or other items to lay between the pallet and the fan housing to align
motor brackets with motor and to support the housing.
6
