XM2-RFID
User Manual
4-1
Janam Technologies LLC
4
Resetting the XM2-RFID
In addition to On (Resume) and Off (Suspend) functions, XM2-RFID mobile computers provide
two device reset (boot) procedures.
On (Resume)/Off (Suspend)/ Reset Functions
To Suspend or Resume the XM2-RFID operation:
1.
Press the
Power key
once to suspend operation
2.
Press the
Power key
again to resume.
Soft Reset
A soft reset or warm boot restarts the device and reboots the operating system. Applications and
files remain intact. However, any data in RAM that has not been saved could be lost. Make sure
to save any open work before executing a soft reset.
To perform a soft reset (warm boot):
1.
Remove the battery door and, using the stylus, press and release the red “Reset” button
found in the battery compartment.
2.
Wait for the device to boot.
Master Reset
A master reset or clean boot returns the XM2-RFID to factory settings, removing ALL applications
and data stored on the device. Any files or programs stored in the \Application folder or a MicroSD
card will remain. Be sure that all data is backed up before performing a master reset.
To perform a master reset (clean boot):
1.
Remove the battery door.
2.
Hold down the
“Windows”
and yellow hard key and tap the red reset switch in the
battery compartment.
3.
Immediately turn the device over and while keeping the keys above pressed, add the
“#”
key
and hold all three until you see the LED flash green.
4.
When clean boot is completed, calibrate screen.
