Jamara Beaver DHC 2 V2, Инструкция по эксплуатации, Страница: 16 / 24

16
77. Then along the bar between bar and rudder with
a utility knife to cut.
78. A rudder is created which can be fitted with hindge tape or
foil.
79. Overlaying rib pieces can now be sanded.
81. The surface shows the inside strut backwards.
The servo frame is applied to the wing.
80. To avoid creases in the foil around the rudder, a frame is
created with 1.5 mm balsa.
After applying the covering foil, the frame can be cut-out
again and the rudder horn can be finally glued.
82. The struts can be covered with balsa strips.