Jamara Beaver DHC 2 V2, Инструкция по эксплуатации, Страница: 13 / 24

13
59. Put a wet cloth on the outer wings so they can be formed
easier.
Tip:
Make sure all is aligned!
The underside has to lay on the plan until the glue is dried.
You may have to put weights on the opposite side. 1.5 mm
wood can be laid under the first rib to produce a cant.
60. The edges of the planking is sanded until you reach the ribs.
61. The next step is to plank the underside.
63. Plank and sand the upper part.
62. In the area of the wing screw, a end bar is applied to avoid
extruding.
64. Cut of the planking until you reach the first rib. Cut off with
approx 4 - 5 mm to the bar.