Jamara Beaver DHC 2 V2, Инструкция по эксплуатации, Страница: 12 / 24

12
53. The landing flap bars are aligned. 54. The aileron panel at an oblique angle.
Tip:
To hang up the wing again to plan, the lower projection of
the aileron panel remove the same.
57. Glue supports to the ribs.
55. Glue the edges of the rudder to the bar. 56. Put a piece of 1.5 mm balsa under the first rib to make sure
the end bar is not move forward slightly.
58. The first third of the wing is now planked.
Tip:
Slide the wood right to the bar and glue to the bar.