JADAK flexpoint™ HS-‐‑1M User’s Manual
Page 36
Snap an Image
Use the command
IMGSNAP
to snap/take an image to with the HS-1M.
You can add arguments for specific usage:
L=1 = use illumination
P=0 = Picture Type (0=decoding, 1=photo, 2=manual)
G=x = Gain value (x=1|2|4|8) (note: only works when P=2)
B=1 = beep on when snapping an image (0=off)
T=1 = wait for trigger (0=off).
More details and additional arguments for
IMGSNAP
can be found in the
HELP
dump list.
Send an Image (to Host)
Use the command
IMGGETX
to get or send an image from the device to the host.
You can add arguments to this command for specific usage:
xm
= sets the send-protocol to X Modem.
jpg
= sends the image as jpeg format (default = bmp)
q=xx = sets the quality of the image, where xx is a value between 1 and 100 (highest quality)
Example
: IMGGETX xm jpg q=30
sends the image as a jpg file via X Modem with a quality of 30
percent.
More details and additional arguments for
IMGGETX
can be found in the
HELP
dump list.
Image Width and Height
Use these commands to show the image’s maximum width and height in pixels.
Maximum Width of Image
Maximum Height of Image