INST 448 Jacuzzi® JVX Series Pool pump V10-17
7
Figure 3A – pump shown without adjustable base
Figure 3B – pump shown with universal base to fit Max E Pro®
Figure 3C – pump shown with universal base to fit WhisperFlo®
(
OPERATION
1.
Prime pump if hair and lint pot is dry as follows – Close off valve on suction line if present. Remove lint
pot lid. Fill lint pot and chamber with water. Replace and secure lint pot lid and seal.
2.
Open all valves, allowing water to flow through pump.
3.
Switch on power to pump, motor to start.
4.
For initial priming of the pump, press the “Menu” button and “FAST” will be displayed on the
screen. The pump will then run at “overdrive” speed and the display will show 2 rotating circles.
The pump will then prime 30% faster than at the conventional maximum speed. During this
priming period the pump will automatically limit its maximum speed according to the systems
total dynamic head and power consumption. Once the pump has primed (or if it fails to prime
within 5 minutes) the speed will drop to the speed that it last ran in “Manual” mode.
5.
If some flow of water does not establish within on half minute, switch off and prime pump again. If pump
does not prime within 3 attempts, check all suction connections for sealing. If these are satisfactory, a
check or foot valve is required to hold water for prime.
6.
If the water flow through pump is always tedious to obtain at start-up after cleaning the lint basket, then
an examination of the system to establish a reason and correct the cause is recommended. Eg. Check
valve, air leaks, faulty seal, cracked lint pot lid, etc.
