Jacuzzi Sense, Руководство по установке, использованию и обслуживанию

Страница: 29 / 44

29
CLEANING THE THERMOSTATIC VALVE
The thermostatic valve is provided with mesh filters to trap any impu-
rities in the water. Over time, these filters could become clogged and,
therefore, inhibit the functions of the mixer tap. To clean them, do the
following:
Turn off the water supply (hot and cold) to the shower enclosure.
Drain the water from the mixing group by placing the devia-
tor ring nut (G) on the position “A - showerhead”. Then set the
showerhead on the floor to improve water drainage. Complete-
ly open the stop tap(R), drain the remaining water, and then close
it again.
(1)Remove the plug (T) from the knob of the mixer.
(2-3-4)Remove the screw (V), slide off the knob (M) and the
cap of the mixer (C).
(5) Unscrew the ring nut (H) that secures the thermostatic
valve.
(6) Ease out the thermostatic valve (L).
Clean the mesh filters with a little brush and rinse. If scale is present,
wash with specific products.
(7) Reassemble the various components by following the same
procedure in reverse order. When installing the knob of the ther-
mostatic valve (M), use care in ascertaining its position with re-
spect to the graduated scale and the safety stop.
(8) Fasten the thermostatic valve so that the screw peg (Q) is
facing downwards, and that it fits into the groove of the brass
component.
Warnings and notes
• Ensure that installation has been carried out by qualified
personnel, in full compliance with legal and current nation-
al regulations.
• This equipment must not be used by individuals (including
children) with limited physical, sensorial and/or cognitive abil-
ities, or individuals who do not have the knowledge necessary
for its use. Children may use this equipment only under strict su-
pervision by a person responsible for their safety.
• This appliance must only be used to serve the purpose for
which it was designed. Jacuzzi does not take responsibility for
any damage resulting from inappropriate use of the appliance.
• It is dangerous to use or access the components of the elec-
trical system while the shower panel is in use.
• After using any “water jet” function, turn off the stop tap. It is advis-
able to turn the diverter to the “showerhead” position.
• If panels shower enclosures are supplied with hot water from an e-
conomic-type gas boiler with mechanical flame adjustment, the
boiler may not be able to provide a continuous water supply at the
required temperature. In this case, if it is not possible to replace the
boiler with an electronic-modulation one, it is advisable to get a
qualified technician to lock the flame modulation of the boiler and
only use the shower panel mixer tap to regulate water temperature.
• The water supply (hot/cold water) must ensure well-balanced pres-
sures. A considerable difference in pressure may prevent correct and
speedy adjustment of the water temperature.
For all maintenance and/or repair operations that require the re-
placement of components, original Jacuzzi
® spare parts must be
used, since failure to comply with this regulation will mean
that the Manufacturer is not liable for any damage.
1
T
G
R
H
C
M
V
2
3
6
8
4
5
L
Q
A