ENGLISH
17
Jacuzzi Whirlpool Bath EL21000B 10/06
TYPICAL BATH FITTINGS
Operation
NOTE: These instructions pertain to all bath products manufactured by Jacuzzi Whirlpool Bath. Not all features dis-
cussed in this instruction pamphlet apply to all baths.
All baths manufactured by Jacuzzi Whirlpool Bath are designed for "fi ll and drain," which means the bath should be drained
after each use and fi lled with fresh water by the next bather. This is a health precaution, as these baths are not designed to hold
water continuously like pools or spas. If you want a unit designed to continuously hold water, see your Jacuzzi Whirlpool Bath
dealer for the complete line of spas available.
Once the bath is installed, remove any residue or foreign materials left over from construction. Paint, tar, or other diffi cult surface
stains can be removed with paint thinner, turpentine, or isopropyl alcohol (rubbing alcohol). NOTE: Use these chemicals only on
SURFACE stains. Other dirt can be cleaned off with a mild liquid detergent on a damp cloth. Scrape off plaster with a wooden
or plastic edge;
do not use metal scrapers, wire brushes or other metal tools, as they will damage the bath's surface.
Water Level
Close the drain and fi ll the bath until water is at least 1" to 2" (25,4 to 50,8 mm) above the highest jet (see water line indicated
in the illustration).
Do not turn on the whirlpool system at any time if the jets are not completely immersed in water.
Running the whirlpool system when there is insuffi cient water in the bath could result in water spraying outside the bath area.
Running the whirlpool system without water will damage the recirculating pump.
IMPORTANT:
When exiting the bath, the water level will drop below the jets which could result in water being sprayed out of the
unit. To prevent this,
you must turn unit OFF before exiting bath.
OPERATING INSTRUCTIONS
1" - 2"
FILL TO AT LEAST
1" - 2" ABOVE HIGHEST JET
DRAIN/OVERFLOW
TYPICAL SALON™ SPA FITTINGS
SALON
CONTROL PANEL
AIR JETS
FULLY
ADJUSTABLE
SIDE JETS
FULLY
ADJUSTABLE
BACK JETS
WATER LEVEL
SENSORS
SUCTION COVER
