Jacuzzi Luxury Bath, Руководство по установке

Страница: 7 / 20

www.jacuzzi.com
Page 7
Installation
English
Chromatherapy Operation
If Chromatherapy fails to work:
• Reset the GFCI.
• Ensure the plug is fully in the outlet.
• Ensure the connectors to the control panel and control box are fully engaged in receptacles.
• Contact your electrician to ensure the proper wiring and power is being supplied to the GFCI.
• Contact Jacuzzi Luxury Bath if the above does not resolve the issue.
Installation Procedures
General Procedures for All
DANGER:
Risk of electric shock!
Turn off the power supply to the GFCI protected circuit.
Before you begin your installation, please read the following:
• Observe all local and building codes.
• Determine which tools will be used during the installation.
• Additional bathtub drain parts and plumbing are commercially available at plumbing and hardware stores.
1. Install drain/overflow according to the manufacturer’s instructions. Refer also to the Technical Specifications Manual.
Watertight installation of the drain is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi
Luxury Bath warranty of this product.
2. Install the faucet at this time (if applicable). It is recommended that the faucet be installed by a qualified plumber. See
special notes on freestanding section for faucetry.
Proper installation of the spout plumbing and compliance with local codes are the responsibility of the in-
staller. Jacuzzi Luxury Bath does not warrant connections of water supply fittings and piping, fill systems, or
drain/overflow systems. Nor is it responsible for damage to the bathtub which may occur during installation.
A non-flammable protective barrier must be placed between the soldering work and the bathtub unit to pre -
vent damage to the bathtub.
G
• Press once to activate color
lighting.
• Press a second time to activate
solid White color.
• Press a third time to turn OFF.
NOTE:
The Up and Down buttons
can be used to select colors or
intensity.
• Press button to activate the
color blending feature.
• Light sequence is as follows:
Blue, Teal, Green, Yellow, Or-
ange, Red, Pink, Purple.
• To select a solid color press
the Up button when the color is
displayed.
• Solid White color only: pressing
will increase the light intensity
NOTE: Default lighting color is solid
Blue.
• Press button to activate the
color blending feature.
• Light sequence is as follows:
Purple, Pink, Red, Orange,
Yellow, Green, Teal, Blue.
• To select a solid color press
the Down button when the
color is displayed.
• Solid White color only: press-
ing will decrease the light
intensity
NOTE: Default lighting color is
solid Blue.