Jacuzzi J-435, Руководство пользователя

Страница: 19 / 80

13
J-445/J-435 Export
6.0 Electrical Installation Instructions
IMPORTANT NOTICE: The electrical wiring of this spa must
meet the requirements of the National Electrical Code/USA
(NEC) and any applicable state or local codes. The electrical
circuit must be installed by a qualified electrician and
approved by a local building/electrical inspection authority.
1.
!
DANGER:
TO DECREASE THE RISK OF SHOCK,
PRODUCT DAMAGE OR ELECTRICAL FIRE.
This spa must be permanently connected (hard-wired) to the power
supply. No plug-in connections or extension cords are to be
used in conjunction with the operation of this spa. Supplying
power to the spa, which is not in accordance with these instructions,
will void both the independent testing agency listing and the
manufacturer’s warranty.
2. The power supplied to this spa must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to
Section 7.0 “Power Requirements” (page 17) for your specific spa
model.
• Wire size must be appropriate per NEC and/or local codes.
• The spa controller’s terminal block will accept a maximum wire size
of 6 AWG.
4. The electrical supply for this product must include a suitably rated
switch or circuit breaker to open all ungrounded supply conductors
to comply with Section 422-20 of the National Electrical Code/USA,
ANSI/NFPA 70. The disconnecting means must be readily accessible
to the spa’s occupant but installed at least 5 feet (1.5m) from spa
water.
5. The electrical circuit supplied for the spa must include a suitable
ground fault circuit interrupter (GFCI) as required by NEC Article
680-42/USA.
6. For Australia/ New Zealand, the spa should be supplied through
a residual current device (RCD) with a rated tripping current not
exceeding 30mA (IEC 60335-2-60).
7. To gain access to the spa’s power terminal block:
J445 - Starting at one side, gently pull the panel to release it from the
mounting clips, Figure A. Slowly and gently tilt the panel forward and
then lift up to remove. Place the panel is a safe location to prevent
damaging it. Remove the foam insulation boards. Then remove the
door screws on the control box.
J435 - Press the retractable push button to release the panel door
from the spa frame, Figure A. Slowly and gently tilt the panel forward
and then lift up to remove, Place the panel in a safe location to prevent
from damaging it. Then remove the door screws on the control box.
8. Select the power supply entrance you want to use, Figure B. Make
sure to install a 3/4" electrical fitting and conduit through the large
opening provided in the bottom of the control box so you can feed
the cable through to the terminal block.