Jacuzzi J-135, Руководство пользователя

Страница: 45 / 60

J-100
13.2 Sanitizing
To destroy bacteria and organic compounds in the spa water, a sanitizer
must be used regularly. Chlorine and bromine are the two most popular
sanitizers used to date. Many other additives are available for your spa.
Some are necessary to compensate for out-of-balance water, some aid
in cosmetic water treatment and others simply alter the feel or smell of
the water. Your authorized Jacuzzi dealer can advise you on the use of
these additives. When adding spa shock (chlorine or non-chlorine) or pH
balancing chemicals activate the jets pump(s) and leave the spa cover
open for a minimum of 20 minutes. By doing this you will allow excessive
chemical vapors to exit the spa, protecting pillows and plastic knobs from
chemical attack.
WARNING:
RISK OF PERSONAL INJURY, DROWNING
OR ENTRAPMENT!
Never leave your hot tub unattended for any reason while the
cover is open and accessible, especially to small children and
animals!
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash
and void the manufacturer warranty for your spa.
!
14.0 Error Conditions/Error Messages
Your spa has a self-diagnostic control system. The system will
automatically display the following if a problem is detected. Always
insist on genuine Jacuzzi replacement parts.
14.1 Panel Displays COOL
Cool Condition - Temperature has dropped 20°F (11°C)
below the current set temperature. The jets pump 1 and the
heater have been activated to bring the temperature within 15°F (8°C) of
the set temperature. No corrective action is required!
Note: This condition is common during first time fill ups or during refills
since tap water is often very cold.
14.2 Panel Displays ICE
Freeze Protection - A potential freeze condition has been
detected. No action is required. Water temperature is below 55°F
(12.78°C). Jets Pump 1 (high speed) and Jets Pump 2 (if equipped) will
activate for 10 minutes, then turn off. Then the pump 1 low speed and the
heater will activate for 10 minutes. The two cycles shall repeat until the
water temperature reaches 65°F (18.33°C). See “Winterizing” (page 46).
41