Jacobsen Ransomes HR 6010, Руководство по эксплуатации

Страница: 12 / 76

Controls
HYDRAULIC LIFT LEVERS
The cutting units can be raised and lowered
by three control levers (A,B,C) situated on
the right hand side of the operators seat
and can be operated as follows:
Centre lever controls Centre Cutting Deck.
(B)
Right hand lever controls R.H. Cutting
Deck. (C)
Left hand lever controls L.H. Cutting Deck.
(A)
NOTE: If any unit is raised out of work then
lowered into work again the cylinder will not
rotate until the mow foot switch is depressed.
To lift: Move the lever(s) backwards and hold
in position until the units are at the required
height.
To lower: Move the lever(s) fully forwards and
release, the unit(s) will lower to ground level.
DO NOT hold lever in forward position.
NOTE: The units will only lift and lower when
the engine is running.
IMPORTANT: If, when cutting, a lift control
lever is accidentally pulled back, the cutting
units will not float over ground undulations
until the lever is pushed fully forward and
allowed to return to neutral again.
CUTTING UNIT SWITCHES
To commence cutting ensure speed limiter
is in mow position and the units have been
lowered. Push bottom of the rocker switch
(G) and depress foot switch (A) Push top of
rocker switch to stop cutter unit rotation.
(Cutting unit stop rotating automatically
when raised.)