Jacobsen Ransomes HR 6010, Руководство по эксплуатации, Страница: 19 / 76

ENGINE: First 50 working hours
and every 250 working hours.
Change Engine Oil.
(a) Warm up the engine first and
then shut it off. Remove oil
drain plug from the bottom of
the crankcase and wipe it off.
(b) Replace the drain plug and fill
engine with 10.6 litres of oil
(with filter).
Fig.1 A Oil Fill, B Dipstick, C Oil fill
Change Engine Oil Filter (A)
(a) Remove single-unit cartridge (A)
(b) Clean area on crankcase.
(c) Apply thin coat of oil to cartridge
gasket before installing.
(d) Tighten filter by hand only.
(e) Check for oil leaks around the
cartridge gasket after engine is
started.
Fig.1
ENGINE MAINTENANCE: Every 500 hrs
Fuel System:
Use Diesel fuel No.2-D (ASTM D975)
See engine manufacturer's manual for
additional information.
Changing fuel filter (Fig.10)
1. Unscrew filter screw (A) from filter
head.
2. Bleed air from system as described
in section 5.5
Fig.10
Bleeding air from fuel system
1. Turn the ignition switch to the ON
position (dont start engine)
2. Open air vent A onto top of fuel filter
to allow air to escape.(Fig.10)
3. Retighten air vent.
4. Open air vent (A) on side of injector
pump to allow air to escape.(Fig.11)
5. Retighten air vent
6. Turn ignition to OFF.
Fig.11