Jacobsen HR-9016T 70538, Техническое руководство по ремонту

Страница: 14 / 52

1-6 4263110-Rev B
SAFETY
1
Inspect Safety Labels
Safety labels are critical to the safe operation of the
mower. Inspect the mower for any damaged, missing, or
unreadable labels. Replace labels as necessary before
placing the mower back in service.
Keep Work Area Clean
A clean, organized, well-lit work area is important to
promote safe working conditions.
• Keep floor clean of debris and clear of parts and
tools.
• Clean up any spilled fuel, oil, and/or chemicals
immediately.
• Store all air hoses and electrical cords properly when
not in use.
Keep Work Area Well Ventilated
!
WARNING
Certain test and adjustment procedures require the
engine to be running. Be sure work area is well
ventilated; never run the engine in an enclosed area.
Use Proper Eye and Face
Protection
!
WARNING
Always wear eye protection while in a shop environment.
• Safety Glasses: Safety glasses offer a minimum level
of protection from flying debris.
• Face Shields: Face shields are often used along with
safety glasses to offer a higher level of protection
when sparks and flying debris are present.
• Vented Goggles: Goggles offer side protection not
offered by safety glasses alone.
• Unvented Goggles: Unvented goggles offer
protection from chemical splashes and vapors.
Park Mower Safely
See Figure 1-2.
!
WARNING
1. Park the mower on a solid, level surface.
Figure 1-2
2. Disengage the cutting units by pushing the mow
switch (2).
3. Lower the cutting units by moving the raise/lower
levers (1) forward.
4. Place 4WD switch (4) in the 2WD position.
5. Move throttle lever (5) to the idle position.
6. Engage park brake.
7. Rotate key switch (3) fully counterclockwise to off
position and remove key.
NOTICE
Never operate the engine without proper
ventilation; exhaust fumes can be fatal if inhaled.
Always use approved personal protection
equipment. Avoid workplace hazards by wearing
properly maintained, approved eye and face
protection. Failure to use appropriate protection
equipment may result in death or serious injury.
Before cleaning, adjusting, or repairing this
equipment, disengage all drives, engage park
brake, and stop engine to prevent injuries.
When performing maintenance other than
adjustments that require the engine to be
running, disconnect the battery negative cables
to prevent accidental starting and bodily injury.
• Permanent damage to the turbocharger may
occur if the engine is shut down without
allowing the turbocharger time to cool.
• To prevent damage, operate the engine with
no load and at half throttle for 3 to 5 minutes
before shutting off engine.
TN4087
2
3
1
5
4