Jacobsen HR 5111, Инструкции по обслуживанию и ремонту

Страница: 45 / 339

GENERAL
The hydrostatic transmission is driven by a telescop-
ing universal joint type drive shaft connected directly
between the hydro and engine flywheel plate.
REPAIR
Repairs are limited to renewing the cross and bearings.
SERVICE
DISASSEMBLY (See Figure 4C-1)
1. Position the joint in a vise as shown.
2. Remove the four snap rings.
3. Using a driver slightly smaller than the outside diam-
eter of the bearing, drive the bearing in forcing the
bearing on the opposite side out.
4. Turn the drive shaft around and driving on the cross,
push opposite bearing out.
5. Repeat Steps 3 and 4 for the remaining bearings.
ASSEMBLY (See Figure 4C-1)
NOTE
During reassembly be sure all the parts are clean
and free of dirt.
1. Start one bearing in yoke ear and position center
cross through yoke.
2. Drive the first bearing flush with outside surface of
ear.
NOTE
Do not bend ear of yoke.
3. Support the ear and using a mandrel the same
diameter as the bearing, drive the bushing slightly
past the snap ring groove.
4. Install the snap ring.
5. Repeat Steps 3 and 4 for the other bearings.
6. After assembly, ensure proper seating by striking
the forged surfaces of the yoke ear one sharp blow
with a soft mallet.
7. Lubricate the joint as described in Section 11.
DRIVE TRAIN
SECTION 4C. HYDROSTAT DRIVE U-JOINT
4C-1
4C
Figure 4C-1. Drive Shaft