Jacobsen GA580, Техническое руководство

Страница: 20 / 68

5 INITIAL INSPECTION AND SET-UP
en-19
5Initial Inspection and Set-Up
5.1 GENERAL________________________________________________________________
The inspection and assembly of the aerator must be done by an authorized technician.
Accessories not included with this product must be ordered separately. See instructions provided with accessory for
installation and parts.
5.2 INITIAL INSPECTION_______________________________________________________
Do a visual inspection of the aerator. Look for indications of wear or loose hardware. Look for any components that are
not included on the aerator or damaged components.
Check the paint and the decals for damage or scratches. The decals supply important information. Replace all missing
or damaged decals.
Check the chain tension.
Lubricate the aerator.
The aerator is shipped with the gearbox completely filled with oil. The oil must be drained to the correct level before the
aerator is operated.
See 8.3
5.3 PTO LOCK _______________________________________________________________
The aerator has a PTO lock installed that prevents the
movement of the gearbox shafts. Remove the PTO lock
before the aerator is attached to the tractor.
When the PTO shaft is not attached to the aerator, install the
PTO lock.
To remove the PTO lock, remove the two pins (B) and remove
the PTO lock (A) from the gearbox shaft. Store the PTO lock
for future use.
To assemble the PTO lock, put the PTO lock (A) on the PTO
shaft. Install the two pins (B) to fasten the PTO lock.
CAUTION
Do not drive the tractor unless you know the controls and the correct operation.
CAUTION
The inspection must be done each day when the engine is turned off. Lower the aerator to the ground, engage the
parking brake, stop the engine and remove the ignition key.
!
!
A
B
B