Jacobsen Fairway 305 Turbo, Инструкции по безопасности, эксплуатации и техническому обслуживанию

Страница: 53 / 144

JACOBSEN FAIRWAY 305 Series CG2
SAFETY AND OPERATION & MAINTENANCE MANUAL
en-51
10.1 GENERAL
The troubleshootijng chart below lists basic problems that may occur during start-up and operation. For more
detailed information regarding the hydraulic and electrical systems contact your area Jacobsen Distributor.
10 TROUBLESHOOTING
Symptoms Possible Causes Action Section
Engine will not start.
1. Glow Plug has not timed out.
1. Reset ignition switch and allow glow plug to
time out before cranking engine.
2. Battery low on charge or
defective. 2. Inspect condition of battery and battery
connections.
3. Fuel tank empty or fuel
contaminated. 3. Fill tank with fresh fuel. Change filter, Bleed air
from lines.
4. Blown Fuse. 4. Replace Fuse.
5. Defective Starter Relay. 5. Test and replace relay if neccesary.
6.Forward/Reverse pedal latch
depressed. 6. Ensure Forward/Reverse pedal neutral latch
not depressed.
7. Mow switch set to cut. 7. Set mow switch to off.
Engine hard to start
or runs poorly.
1. Fuel tank empty or fuel
contaminated.
1. Fill tank with fresh fuel. Change filter, Bleed air
from lines.
2. Air Cleaner blocked or dirty. 2. Check air cleaner, replace as neccesary.
3. Injectors, fuel pump. 3. Consult engine manual.
4. Other Engine Problem 4. Consult engine troubleshooting guide.
Engine Stops.
1. Fuel tank empty 1. Fill with fresh fuel and bleed lines
2. Interlocks not set before
leaving operators seat 2. Set mow switch to off. Ensure forward/reverse
neutral latch is not depressed.
Engine Overheating.
1. Coolant level low
1. Inspect and add 50/50antifreeze solution if
required.
2. Radiator air intake restricted 2. Clean wire mesh guard at radiator.
3. Waterpump/alternator belt or
fan belt loose or broken.
3. Inspect waterpump/alternator belt and fan belt.
Tighten if neccesary.
Battery not holding
charge. Battery light
on.
1. Loose or corroded battery
terminals.
1. Inspect terminals, clean and tighten as
required.
2. Low electrolyte level in
battery.
2. Refill battery with distelled water
3. Alternator belt loose or
broken. 3. Inspectwaterpump/alternator belt. Tighten if
neccesary.
4. Alternator defective. 4. See engine manual.
Cylinders cut
unevenly. Poor
quality of cut.
1. Cylinder to bottom blade not
adjusted properly.
1. Inspect cylinder to bottom blade adjustment
2. Engine speed too low. 2. Check engine speed, run engine at full throttle.
3. Cylinder speed not adjusted
for turf conditions.
3. Adjust cylinder speed for best cut.
4. Cylinder direction lever set
in reverse.
4. Set cylinder direction lever to forward rotation.
5. Ground weight incorrectly
adjusted 5. Adjust ground weight control valve until correct
ground weight is achieved.