Jacobsen 67961, Руководство по обслуживанию

Страница: 19 / 148

MAINTENANCE 4
19
4.4 AIR FILTER _______________________________________________________________
Check the service indicator daily. If red band appears in the
window (B) replace the element.
Do not remove the element for inspection or cleaning.
Unnecessary removal of the filter increases the risk of
injecting dust and other impurities into the engine.
When service is required, first clean the outside of the filter
housing, remove the old element as gently as possible, and
discard.
1. Carefully clean the inside of the filter housing without
allowing dust into the air intake.
2. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
3. Assemble the new element and make sure it seats
properly. Reset the indicator by depressing button (A).
4. Reassemble cap making sure it seals completely
around the filter housing. Dust evacuator must be
facing down.
5. Check all hoses and air ducts. Tighten hose clamps.
Figure 4A
4.5 FUEL ____________________________________________________________________
Handle fuel with care - it is highly flammable. Use an
approved container, the spout must fit inside the fuel filler
neck. Avoid using cans and funnels to transfer fuel. • Fill the fuel tank to within 1 in. (25 mm) below the filler
neck.
• Use clean, fresh, #2, low or ultra-low sulfur diesel fuel.
Minimum Cetane Rating 45. Refer to Engine Manual for
additional information.
• Check fuel lines and clamps every 50 hours. Replace fuel
lines and clamps at the first sign of damage.
• Store fuel according to local, state, or federal ordinances
and recommendations from your fuel supplier.
• Never overfill or allow the tank to become empty.
4.6 FUEL SYSTEM ____________________________________________________________
Refer to Section 6.2 for specific maintenance intervals.
Before replacing any filter, thoroughly clean the filter
housing, and the area around the filter. Dirt must not be
allowed to enter into fuel system.
Bleed the fuel system after the fuel filter and lines have been
removed, or the fuel tank has become empty. See Engine
Manual.
To change fuel filter:
1. Close fuel valve on tank and remove and discard the
existing filter.
2. Apply a light coat of oil to the gasket and hand tighten
new filter.
3. Fill fuel tank. Open fuel valve on tank and bleed the
filter. See Engine Manual.
A
B
LF017
WARNING
Never remove the fuel cap from the fuel tank, or add fuel,
when the engine is running or while the engine is hot.
Do not smoke when handling fuel. Never fill or drain the
fuel tank indoors.
Do not spill fuel and clean spilled fuel immediately.
Never handle or store fuel containers near an open flame
or any device that may create sparks and ignite the fuel
or fuel vapors.
Be sure to reinstall and tighten fuel cap securely.
!