Jackson 100 B/PRB, Руководство по обслуживанию, Страница: 36 / 55

TROUBLE SHOOTING GUIDE
PROBLEM CAUSE SOLUTION
Low rinse temperature 1- Machine using more water 1- If this trouble occurs, it
indication than normal by rinse running should be determined that
throughout wash cycle, caused the rinse is running during
by faulty rinse microswitch in the wash cycle by in
timer specting the rinse sole
noid and by disconnecting
the wash motor lead at
the terminal board on the
control panel. See instruc-
tion page on timer
2- Incoming water supply not 2- Provide adequate supply of
hot enough hot water, see specifica-
tions sheet
3- Heater switch faulty 3- Check heater switch
4- Setting on thermostat con- 4- Try new setting. Move the
trol has been moved from thermostat control clock-
original factory setting wise for higher setting.
5- Thermostat faulty 5- Check thermostat, see
instruction page
6- Heater faulty 6- Check heater, see instruction
page
7- Contactor faulty 7- Check contactor, see instruc-
tion page
8- Thermometer faulty 8- Remove thermometer and
check in hot water against
an accurate thermometer
Water leaks from 1- Spray arms are not moving 1 - See instruction page on
top of door freely or ends bent down preventive maintenance -
ward pull upward on ends of
longest wash spray arms ½.
Machine wash and 1- Timer defective and stopped 1 - Move start switch to middle
rinse do not operate in timed cycle position (start switch is
three position) UP - Start
CENTER-Off, DOWN -
Start. See instruction
page on timer.
Machine does not 1- Circuit breaker tripped 1-Reset circuit breaker on
operate at all wall panel. Check voltage
to machine at L1 and L2
at terminal board #TB2
35