„
SAFETY TIPS
1. ALWAYS CHECK FOR LEAKS AFTER EVERY GAS TANK CHANGE.
2. ALWAYS CHECK FOR LEAKS OF EVERY CONNECTIONS BEFORE EACH USE.
3. IF ANY GREASE OR HOT ITEMS FALLING FROM THE GRILL ONTO THE VALVE, REGULATOR,
HOSE, ANYTHING CONVEYING THE GAS, CLOSE THE GAS IMMEDIATELY. CHECK THE
CAUSE, AND REMOVE THE CAUSE. REPERFORM THE LEAK TEST BEFORE CONTINUING.
4. DO NOT REMOVE THE GREASE TRAY IF THE GRILL
HASN’T COMPLETELY COOLED.
5. CLOSE ALL CONTROL KNOBS AND L.P. TANK VALVE WHEN THE GRILL IS NOT IN USE.
6. NEVER MOVE THE GRILL WHILE IN USE OR STILL HOT.
7. PUSH THE GRILL FORWARD, DO NOT PULL WHEN MOVING IT.
8. CHECK ALL GAS SUPPLY FITTINGS FOR LEAKS BEFORE EACH USE. IT IS HANDY TO KEEP
A SPRAY BOTTLE OF SOAPY WATER NEAR THE SHUT-OFF VALVE OF VALVE OF THE GAS
SUPPLY LINE. SPRAY ALL THE FITTINGS. BUBBLES INDICATE LEAKS.
9. DISCONNECTED L.P. TANK IN STORAGE OR BEING TRANSPORTED MUST HAVE A SAFETY
CAP INSTALLED. DO NOT STORE AN L.P. TANK IN ENCLOSED SPACES LIKE CARPORT,
COVERED PATIO, PORCH, GARAGE OR OTHER BUILDINGS.
10. NEVER LEAVE A GAS TANK IN A RECREATIONAL VEHICLE OR BOAT WHICH MAY BECOME
OVERHEATED BY THE SUN.
11. DO NOT STORE L.P. TANK IN OR NEAR AN AREA WHERE CHILDREN PLAY.
12. DISCONNECTED THE TANK AND REMOVE FROM THE GRILL IF THE GRILL IS STORED
INDOORS.
13. ANY OTHER PROBLEM, SEE
“TROUBLESHOOTING” OR CONTACT JACKSON GRILLS AT
888-287-3333.
INSTALLER FINAL CHECK LIST
!!!
WARNING
!!!
PRE-START CHECKLIST:
Property damage, bodily harm, severe burns, and death could result from failure to
follow these safety steps. These steps should be performed after the grill has been
assembled, stored, moved, cleaned, or repaired, DO NOT operate this grill until you have
read and understand ALL of the warning and instructions in this manual.
ˆ
Ensure that the grill is properly assembled.
ˆ
The LP regulator & hose connected to grill are provided by the manufacturer.
ˆ
Inspect the natural gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it
is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior the grill being used.
ˆ
Leak check all gas connections and hose,
ˆ
All internal packaging removed.
ˆ
Burners are sitting properly on orifices.
ˆ
Knobs turn freely.
ˆ
Properly place the empty grease tray onto grease tray brackets to catch grease during use.
ˆ
User informed of gas supply shut off valve location.
ˆ
Position your grill on lever ground in a well- ventilated location, at least
36” clearance maintained
from combustible materials, buildings and overhangs.
ˆ
Ensure that all electrical supply cords are properly grounded. Keep any electrical supply cord and the
fuel supply hose away from any heated surfaces. Hose should be at least 3 inches from hot surfaces.
ˆ
There is no unprotected combustible construction material over the grill
ˆ
Do not obstruct the flow of combustion and ventilation air.
19
Содержание Classic PG-50403SRL
Страница 6: ...EXPLODED VIEW 6 ...
Страница 11: ...5 6 7 8 9 10 11 ...
Страница 13: ...Step VI When the grill is in the location step on the brakes of the casters by foot for hold still 13 ...