Jackson Grills Classic PG-50403SRL, Руководство по сборке, использованию и уходу

Страница: 18 / 27

LEAK TESTING
„
GENERAL
Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas
tightness check must be performed at the installation site due to possible mishandling in shipment, or
excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks,
or immediately check if the smell of gas is detected.
„
BEFORE TEST
1. Make sure that all packing material is removed from the grill including the burner tie-down straps.
2. Do not smoke while leak testing.
3. Never leak test with an open flame.
4. Make a soap solution with one part liquid detergent and one part water. Prepare a spray bottle,
brush, or rag to apply the solution to the connections. For the initial leak test, make sure the L.P.
cylinder is full.
5. Grill must be leak tested outdoors in well-ventilated area, away from ignition sources such as gas
fired or electrical appliances, and flammable materials.
6. Keep grill away from open flames and/or sparks while testing.
„
TO TEST ON PROPANE GRILL (ITEM# JCSCART-2):
1. Make sure all control knobs are in the
“OFF” position.
2. Make sure the regulator is connected to the L.P. tank tightly.
3. Completely open L.P. tank valve by turning counter clockwise. If you
hear a “POP” sound, turn gas
off IMMEDIATELY, it indicates a heavy leak at the connection. Call your gas dealer or fire
department.
4. Check every connection from the L.P. tank up to and including the connection to the manifold pipe
assembly (the pipe that goes to the burner) by brushing or spraying the soapy solution on the
connections.
5. If soap bubbles appear, there is a leak. Turn off L.P. tank valve IMMEDIATELY and retighten
connections. Open L.P. tank valve again, and recheck.
6. Always close the L.P. tank valve after leak test by turning clockwise.
Only those parts recommended by the manufacturer should be used on the grill. Substitution can void
the warranty. Do not use the grill until all connections have been checked and do not leak.
„
TO TEST ON NATURAL GAS GRILL (ITEM# JCSCART-NG / JCSCART-2NG):
1. Make sure all control knobs are in the
“OFF ” position.
2. Turn on the natural gas supply. If you hear a rushing sound, turn gas off immediately. There is a
major leak at the connection. Correct before proceeding.
3. Create a mixture of half water and half liquid dishwashing soap. Brush soapy solution onto the
following:
A. Quick-disconnect coupler
B. The full length of gas supply hose
C. Gas supply connection to gas manifold.
C
A
B
18