JAC HFC1061, Руководство пользователя

Страница: 42 / 56

78
2. Clutch trouble shooting
Trouble symptom and probable cause Checking and remedy
3. Clutch can't release completely
a 援 Too long free play of pedal
b 援 Crack or distort of wave sheetc 援 Broken damper spring
a 援 Adjust 3-5mm
b 援 Replace c 援 Replace
1. Shaking clutch
a 援 Overloading
b 援 Not start in low gear
c 援 Defective release bearing or insufficient oil
d 援 Corrugated fin cracked, friction lining worn, loose rivet,
damper spring broken, or damper fin broken down
a. Load as rated
b. Start in first gear when loading much
c. Clean, lubricate or replaced. Replace
2. Clutch slip
a 援 Thin friction lining, rivet reveal, or oil coat
b 援 Weak pressure of diaphragm spring
c 援 Too short free play of pedal
d 援 Vehicle loads too much
e 援 Not start in low gear
f 援 The pedal is held pressed when running
a 援 Clean, or rivet a new friction lining
b 援 Replace
c 援 Adjust to 3-5mm
d 援 Load as rated
e 援 Start in low gear
f 援 Change bad driving habit
OWNER 爷 S MANUAL for
HFC1061,HFC1063,HFC1083
series trucks
79
Trouble symptom and probable cause Checking and remedy
1. Noise or vibration of driveshaft
a 援 Over- worn universal joint
b 援 Bending driveshaft
c 援 Loose couple flange or center bracket bolts
e 援 Insufficient lubrication
a 援 Change spider direction or replace universal joint as 鄄
sembly
b 援 Align or replace
c 援 Screw
d. Replace
e 援 Fill up after cleaning
2. Overheating center bracket
a 援 Oil seal is too tight
b 援 Inclination between driveshaft and crankshaft is too big
c 援 Insufficient lubrication
a 援 It will disappear along with traveling
b 援 Check and adjust the inclination
c 援 Fill up regularly
3. Drive shaft trouble shooting