J/Boats J/88, Руководство пользователя

Страница: 14 / 58

J88 OWNER MANUAL 14
Commissioning Checklist
Pre-Launch
___ Read equipment owner manuals
___ Pre-rig mast and check installation of:

halyards

blocks

electronics

shrouds

spreader end chafe guards

shroud spinnaker protection

lifeline pins
___ Pre-rig boom
___ Bottom painted or touched up
___ Saildrive leg touched up – engine intake holes
clear of any debris or growth.
___ Check propeller/zinc
___ De-winterize engine and check status of:

engine oil/ filter

coolant level

transmission fluid level

water intakes/filter

fuel lines/filter
___ Check battery charge
___ Check all hose clamps, tighten as required
___ Close all seacocks
___ Wire tie wooden plugs near all thru-hulls
Loose Gear
___ Fenders and lines
___ Dock lines
___ Winch handles
___ Ignition/boat keys/combination
___ Bilge pump handle
___ Double-check sling locations and mark
___ Anchor, chain and rode
___ Fire extinguishers installed
___ First aid kit
___ Coast Guard Required Safety Gear
Launch
___ Check for leaks
___ Check seacocks
___ Check engine seal for leaks
Engine Start
___ Read engine owner’s manual
___ Open raw water valve on Saildrive leg
___ Start engine
___ Check exhaust for cooling water flow
___ Check oil press., water temp., charging gauges
___ Check transmission- forward/reverse
___ Check Saildrive seal
Steering System
___ Attach Tiller Extension
___ Check for free rotation of rudder
___ Check SS pins are secured
Step Mast
___ Check & remove SS deck mast step bolts
___ Hoist spar and lower to deck (or pin aft hole of step and
rotate mast up in place with a safe means of lifting)
___ Be sure to thread mast wires down the chase way into
the interior
___ Install both SS bolts for the mast step
___ Thread headstay through furler drum and attach
turnbuckle to stemhead fitting in anchor locker.
___ Attach all shrouds and hand tighten.
___ Dock tune shrouds.
___ Attach and rig backstay and cascade system.
___ Install the mast through bolt just above the step.
___ Run and connect mast junction box wires (on centerline
forward to main bulkhead and to junction box in head
area).
Rigging
___ Install boom
___ Lead all halyards to stoppers on cabin top
___ Rig single line reef system.
___ Install and connect boom vang
___ Rough tune spar
Systems Check
___ Fill optional water tank
___ Fill fuel tank
___ Check operation of electrical systems, pumps, head,
etc.
___ Check sailing electronics
Trial Sail
___ Raise and lower sails to check for fit
___ Monitor engine performance
___ Check bilge for leaks
___ Check sailing electronics
___ Check for backstay stretch