J/Boats J/88, Руководство пользователя

Страница: 47 / 58

J88 OWNER MANUAL 47
Annual Maintenance Checklist
Running Rigging
___ Check running rigging lines for wear at splice, turning blocks,
etc.
___ Inspect blocks and shackles for wear. Clean and lubricate or
replace as necessary.
___ Service winches, check for free spinning operation (bearings)
and ratchet stop action (pawls).
Deck Hardware
___ Check lifeline integrity, stanchions, and pulpits.
___ Check all cleats for signs of fatigue. Tighten fasteners or
replace as required.
Steering System
___ Check rudder for impact damage or cracks.
___ Check rudder hardware for wear or play.
Thru Hull & Seacocks
___ Check seacock integrity, operation, and watertightness.
Replace, reassemble, and lubricate as required.
___ Check hose attachment and clamps.
Electrical
___ Disconnect power source when making repairs or adjustments
to electrical systems.
___ Check battery charge, terminal connections.
___ Check electrical panel, breakers, and switch condition and
operation; tightness of wire connections.
___ Check running light operation.
___ Check ground wire attachment to keel, mast, and engine.
Engine & Drive Train System
___ Read engine owner’s manual maintenance guide.
___ Check engine fluid levels and systems for leaks- shut-off
controls.
___ Check throttle action - start and stop controls, cable clamps, etc.
___ Check exhaust system soundness, hose clamps.
___ Check coolant system, hose clamps, intake, and filters.
___ Check transmission shift lever action, control cables, clamps;
fluid level and alignment.
___ Check prop attachment, zinc, and Saildrive.
___ Check all engine wire connections.
Fuel System
___ Check fuel tank and gauge, hoses, clamps.
___ Check fuel fill hoses and connections.
___ Check fuel filters.
Keel
___ Check keel bolt nuts for tightness. Do not arbitrarily tighten bolts
unless you’ve experienced a severe grounding. If there is
concern for leakage, consult your dealer or professional yard.
Plumbing
___ Check bilge pump function, electrical wiring, hose clamps,
and strainer. Clean, disassemble, lubricate as required.
___ Check head and holding tank hoses, clamps, connections,
and valves.
Water System
___ Check water tank hoses, clamps, valves, connections.
___ Check water heater hoses, clamps, electrical wiring.
___ Check water filters.
Mast & Standing Rigging
___ Visually inspect all mast termination fittings and halyard
sheaves and exits.
___ Untape spreader ends and clevis pins inspect and re-tape