J.ASSY VISUM Monitor, Руководство оператора

Страница: 7 / 42

VISUM |
7
Installation | Monitor
1. Disassemble the Monitor bracket by removing the two side
nuts.
2. Clean the installation surface with a cloth and alcohol.
3. Remove the film from the double-sided tape and fasten the
bracket to the surface by pressing the whole area of the tape.
4. Wait for 15 minutes and then mount the Monitor on the
bracket with the two side nuts.
5. If you install the bracket on a glass surface, put the anti- UV
tape on the opposite side of the glass in order to protect the
double-sided tape from the sun.
6. Press the button to turn on the Monitor and hold it for 5
seconds to turn it off.
Alternatively, the tape may be removed to mount the bracket
with screws or attached to a bar with clamps or RAM Mount kit
(not included).
ATTENTION:
The Monitor should be installed with the antenna
in a vertical line and avoid putting the antenna in
the horizontal position.
The Monitor should be installed with the best
possible line of sight to the sensors in order to
avoid communication problems.
Avoid installing the monitor close to the cab
ROPS column. Keep a minimum distance of
12 in. between monitor and column.