MODEL MAY VARY
Distributor Dish
The distributor dish, structural members, structural
fasteners, and mounting brackets are constructed
of stainless steel.
Distributor Dish
- Near-laminar flow is achieved
by the Machine due to its uniquely designed
distributor dish. The impeller rotates while sitting
within the lower half of the distributor dish. There
are also small water passages located below the
dish to strengthen the induced flow effect (water
movement occuring between the lower water layer
entering the machine and the upper water layer
leaving the dish).
The top lip of the distributor dish is set from 3/4
inch to 2.5 inches (2 cm to 6.4 cm)
(Please refer
to the table below for exact settings)
below the
surface of the water to achieve best flow results.
The distributor dish depth is set by rotating the
turnbuckles located on the float arms.
Distributor Dish
Machine Model
Water Level
2500
3/4 in to 1 in (2 cm to 2.5 cm)
5000
1 in to 1 1/2 in (2.5 cm to 3.8 cm)
7500
2 in to 2 1/2 in (5.1 cm to 6.4 cm)
10000
2 in to 2 1/2 in (5.1 cm to 6.4 cm)
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB and GF Large Frame Mixers
10267_20200220
O&M_GF10000_10492_20201020 - 9
