56
Setup performs a check (A message will be displayed).
This message won’t appear if your computer can't locate your CD-ROM drive. If you
haven’t installed the correct CD-ROM driver, please consult your drive's documentation
or contact your hardware manufacturer.
6.
Press <ENTER>.
Microsoft ScanDisk will check your disk drives for errors.
7.
When ScanDisk finishes, press the
X
key.
Setup will initialize. Then, Windows 98 Setup begins.
8.
Please follow the instructions that are displayed.
Note: Setup may ask you to insert your original Windows 95 or Windows 3.1 disks if
you're using the upgrade version of Windows 98.
5.5.1.2 Installing the floppy disk version of Windows 98
1.
Place Setup disk 1 into your floppy disk drive.
2.
Restart your computer.
3.
At the MS-DOS prompt, type the word
setup
and press <ENTER>.
The Windows 98 Setup wizard will begin.
4.
Please follow the instructions that appear.
5.5.2 Windows NT
5.5.2.1 Installing the CD-ROM version of Windows NT using SCSI controller
1.
Prepare a 1.44MB blank diskette
2.
Enable CD-ROM Bootable and Set boot sequence first priority is CD-ROM.
3.
Place the Iwill Power Installer CD into the CD-ROM drive
4.
Boot from Iwill Power Installer to create Windows 9x/NT driver diskette from CD-
ROM by selecting FMS Disk1 for
Win95/NT
5.
Place the Windows NT 4.0 CD-ROM in the drive.
6.
Press <F6> when the screen show following messages: Setup is inspecting your
computer’s hardware configuration …
7.
Press <S> to specify additional SCSI adapters.
8.
Select <Other> to load manufacture supplied software driver.
9.
Place
the SCSI driver diskette for Windows NT 4.0
into the floppy drive.
10.
Press <ENTER> when SCSI driver is ready.
11.
From list select the proper SCSI controller driver:
12.
Example: Adaptec AHA-294xU2/295xU2/395xU2/AIC-789xPCI SCSI Controller
(NT 4.0)
13.
Press <ENTER> to continue if you have no other SCSI controller to install. Or, repeat
steps 3-7 to install all drivers as needed.
Содержание BD100 Plus
Страница 14: ...14...
