- 3 -
Safety instructions
●
Attention to magnetic force
A pair of strong magnets is mounted in the pump and may cause personal
injury. Follow "Disassembly & Assembly" section when dismantling and/or
assembling the pump.
●
Do not run pump dry
Do not run pump dry (Operation without liquid). Friction heart in the dry run-
ning causes the pump damage. If the pump is operated with a suction side
valve closed, the pump runs dry.
Note that the CF type of high density carbon bearing can run dry within one hour.
●
Restriction on pump operator
The pump must be handled or operated by a qualified person with a full
understanding of the pump.
●
For a specified application only
Use of the pump in any application other than those clearly specified may
result in pump failure or damage.
●
Static electricity
Take countermeasures to remove the static electricity when low electric
conductivity liquids such as ultra-pure water and fluor inactive liquid (e.g.
Fluorinert
TM
) are handled. Otherwise, the static electricity may generate in
the pump and may cause static discharge.
●
Static electricity
Always run the pump for air elimination before full operation. Note that
hydrogen peroxide and sodium hypochlorite easily generate gas. If the
pump runs without full air elimination, the pump is damaged by friction heat.
●
Countermeasure against efflux
Take a protective measurement against accidental chemical efflux and
splash at pump or piping breakage. Also, take an appropriate measure-
ment to prevent accidental outflow from directly soaking into the ground.
Otherwise, It leads to personal injury or environmental damage.
●
Pump disposal
Any used or damaged pump must be disposed of in accordance with local
laws and regulations as an incombustible (Consult a licensed industrial
waste products disposing company.). Neutralize and flush out chemicals
before disposal. Do not incinerate fluororesin parts. Fluororesin emits harm-
ful gas when it is burnt and affects human health and environment.
CAUTION
Prohibited
Prohibited
Содержание AMP 40
Страница 6: ...4 Outline 1 Unpacking Inspection 5 2 Model code 6 3 Operating conditions 7 4 Part names 8...
Страница 11: ...9 Installation 1 Before installation 10 2 Piping 11 3 Wiring 14 4 Protection equipment 14...
Страница 17: ...15 Operation 1 Before operation 16 2 Operation 17 3 Shutdown 17...
Страница 20: ...18 Maintenance 1 Troubleshooting 19 2 Maintenance Inspection 21 3 Disassembly Assembly 23 4 Spare Wear parts 29...