14
Chargemaster Pinner Superbar
5101167 Rev. F
7. MAINTENANCE
NOTE –
Only qualified service personnel are to perform maintenance tasks.
CAUTION –
Electrical Shock Hazard
De-energize all power supplies before performing any maintenance tasks.
Cleaning Charging Bars
1.
DAILY
: Dust or dirt around the emitter pins will reduce the effectiveness of
the Pinner Superbar. The bar should be cleaned daily to prevent deposits from
accumulating. Use the cleaning brush supplied with the bar and then blow off with
clean, dry compressed air to remove loose particulate.
NOTE –
Never scrape emitter pins with hard or sharp objects that may damage their
points.
2.
EVERY TWO WEEKS
: Wipe all exterior surfaces of the bar, mounting hardware,
and insulated support frame using a clean soft cloth. If necessary, dampen the
cloth with isopropyl alcohol to remove inks, conductive contaminants, or resistant
coatings.
CAUTION –
Fire Hazard
Ensure all traces of alcohol have been removed and the static bar is completely
dry before energizing the power supply.
NOTE –
The alcohol must not contain additives. Never use harsh solvents such as
lacquer thinner, naphtha or acetone; they will attack the bar housing material.
NOTE –
Do not pour alcohol directly onto the bars, and do not soak the bar or any
of its components in alcohol.
3.
EVERY THREE MONTHS
: Replace ionizing pins that have become dulled (see
Step-B below).
Replacing Ionizing Pins
NOTE –
Only qualified service personnel are to perform maintenance tasks.
CAUTION –
Electrical Shock Hazard
De-energize all power supplies before performing any maintenance tasks.
