SYNTHESIZED SETS
USER MANUAL
31
7. DISPLAYING THE CODE AND THE WORKING CHANNEL OF THE
SET
7.1. DISPLAY OF CODE
If you want to know the code of the set, the receiver can display it by simply following a series of
steps.
To start displaying, the set should be in stand-by. Press the push-button located on the base plate of
the receiver for 1 to 2 seconds, and the sequence will start. The code will be divided into 6 characters
expressed in hexadecimal system. By observing the following table, you will be able to know the
number displayed through the leds depending on the character to be expressed:
Code character
(Hexadecimal value)
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Number of pulses
(Decimal value)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
For each of the 6 characters to be displayed, one of the leds will be used, and this led will give as
many pulses indicated by the corresponding character of the code. If it starts by S1 with the first
character of the code (reading from left to right) and ends with which displays the last character of
the code.
To indicate that the display of the character has ended, all the leds will flash once (short pulse) except
the one which is displaying. This sequence will be repeated continuously until the push-button is
pressed for 1 to 2 seconds, to pass on to the next character.
Follow the same procedure for the remaining characters until the 6 characters of the code of the set
have been displayed, and the receiver will return to stand-by.
If at any time during the display process the receiver receives a start-up order from the transmitter,
displaying will end and it will pass on to the working mode.
To understand this process better, an example of a code and the result of the display is given.
The code of the example is:
01A38E
.
Led
S1 S2 S3 S4
Code
0 1 A 3 8 E
Number of led pulses
0
1
10
3
8
14
The sequence of the example would be:
• All leds flash.
• All leds flash except S1 until P1 is pressed.
• One pulse of S2 and all the leds flash except S2 until P1 is pressed.
• 10 pulses of S3 and all the leds flash except S3 until P1 is pressed.
Содержание BETON
Страница 1: ...USER MANUAL SYNTHESIZED SETS...
Страница 2: ......
