PM605KT/PM605KT-B Technical documentation
30
3
Insert the Cable and Shaft from MDR
through Mounting Bracket then tighten.
■
■
Recommended tightening Torque:
27 N
･
m
Do not force through the cable and
housing connector, avoid damage
during tightening of the Mounting
Bracket.
■
■
Leave enough gap between A
and B in figure to the right the
attach the Mounting Bracket to
ease the installation.
BF (Between frame) length
4
Tighten the MDR shaft firmly by fastening
hex bolts (M8 x 25) for mounting bracket .
5
Hold the MDR attaching shaft into the
bracket, and fastening Hex socket head cap
bolt (M8×25) and dedicated nuts.
■
■
A a gap 2 to 5mm is required
between the frame inside
dimension and MDR.
Wrench
Wrench
1
A
B
Hex bolt (M8 x 25)
Hex bolt (M8 x 25)
Spring washer (M8)
Hex socket head cap bolt
(M8 x 25)
Cable (spanner)
Cable side
Toothed washer nut: (M8)
Spring-loaded
shaft
Dedicated nut
Hex wrench
■
As shown in the below figure, make
sure that the spring loaded shaft
pops out from the frame hole.
Spring-loaded
shaft
Mounting
bracket
No.MBK-0K1
No.MBK-0K1
No.MBK-0K1-7
＊
If the distance between motor side attaching
shaft and top of frame is 23 to 33mm, cut the
bent part of top of frame for 51mm or over.
(Refer to page 28)
6. Installation
MDR installation
Recommended tightening Torque:
27 N
･
m
Recommended tightening Torque:
27 N
･
m
Spring washer (M8)
Spring washer (M8)
Spring washer (M8)
Safety precautions
Preparation Before Installation
Check product
Installation
Maintenance
Appendix
Original notice - A1.1
