HMPRO35 OPERATOR’S MANUAL
9
www.itmtools.com.au
PRO-36
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
9
4. STARTUP AND OPERATION
4.1. Installing and removing the annular cutter
Unplug the power cord. Turn the handles to the right (
1
) to lift the motor. Use gloves
to put the correct pilot pin into the cutter (
2
). Use a dry
cloth to clean the spindle and
the cutter. Put the cutter into the spindle (
3
) so that the flat surfaces (
4
) align with the
screws (
5
). Use the 4
mm hex wrench to tighten the screws.
To remove the cutter, loosen the screws (
5
) with the 4
mm hex wrench.
Fig. 1.
Installing the annular cutter
2
1
3
5
4
