HMPRO35 OPERATOR’S MANUAL
7
www.itmtools.com.au
PRO-36
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
7
20. Do not use on surfaces that are rough, not flat, not rigid, or have rust, paint,
chips, or dirt.
21. Use the saf
ety strap to attach
the machine to a stable structure. Put the strap
through the hole in the machine body. In the horizontal position, attach the strap
to the carrying handle. Do not put the strap into the buckle from the front.
22.
Use eye and ear protection
and protective clothing. The clothing must not be
loose.
23.
Be careful when drilling in plates thinner than 10 mm (0.4″). The clamping force
depends on plate thickness and is much lower for thin plates.
24.
Each time before you put the machine on the workpiece, r
ub the workpiece with
coarse-grained sandpaper. Make sure that the full bottom of the base touches
the surface.
25.
Do not touch chips or moving parts. Do not let anything catch in moving parts.
26. After use, clean the machine and the tool. Do not remove chips with bare hands.
27.
Unplug the power cord before you do mainte
nance or install/remove parts.
28.
Repair only in a service center appointed by the seller.
29.
If the machine falls, is wet, or has any damage, stop the work and immediately
send the machine to the service center for check and repair.
30. Do not leave the machine when it operates.
31.
If you are not going to use the machine, remove the cutter and the pilot pin from
the holder. Then, remove the machine from the work area and keep it in a safe
and dry place.
32.
If you ar
e not going to use the machine for an extended period, put anti-corrosion
material on the steel parts.
