HMPRO35 OPERATOR’S MANUAL
12
www.itmtools.com.au
PRO-36
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
12
Fig. 3.
Securing the machine from
falling with the safety strap
Turn the handles to the left to put the cutter above the workpiece.
For vertical drilling, fill the cooling system bottle with coolant. Do not use only water
as the coolant. But you can mix water and drilling oil. Then, make
sure that the cool-
ing system works correctly. To do this, lightly loosen the bottle cap and use the lever
to open the bottle valve. Then, turn the handles to the left to apply a light pressure on
the pilot pin. The coolant should fill the system and start
flowing from the cutter.
The cooling system works by gravity. Thus, in the inverted or horizontal position,
use coolants under pressure or in the form of spray or paste.
Do not allow coolant to
run into the motor.
INCORRECT
CORRECT
✓
Vertical drilling
Inverted drilling
Horizontal drilling
