ITEM Work bench 4 E FIFO, Руководство пользователя

Страница: 8 / 16

8
d
M
Table 4 E Table E
4. Setting up the height-adjustable work bench
This height-adjustable work bench is intended as a permanent fixture in an area
that is protected from the weather.
ƒ
The area should be free from mould and fungus and show no traces of
rodents or other pests.
ƒ
Do not install or use in close proximity to industrial plants that produce
chemical emissions.
ƒ
Do not install or use near sources of sand or dust.
ƒ Do not install or use in an area that is regularly exposed to high-energy
surges such as those caused by presses or heavy machinery, for example.
ƒ Resistant to many of the substances usually encountered in the production
area, such as water, mineral oil, grease and detergents. In case of doubt
regarding resistance to certain chemicals such as test oil, alloyed oils,
aggressive cleaning substances, solvents or brake fluid, we advise that you
consult your specialist representative.
ƒ
Avoid long periods of contact with highly acidic or alkaline substances.
ƒ Consult the manufacturer if using in very salty air.
4.1 Environmental considerations
Work bench designs must take into account
the maximum permissible torque load for the
table columns of M
max.
= 140 Nm.
4.2 Levelling the work bench
Table 4 E FIFO
To set up the assembled, height-adjustable work bench, you will need the
following tool:
ƒ Spirit level
Faults may occur as a result of incorrect set-up or start-up. The height-adjust-
able work bench may be damaged and the service life may be shortened.
ƒ When setting up the work bench on uneven ground, use the spirit level to
ensure it is square and axially parallel.
ƒ
Do not load the table columns to the point that they start to deflect.
ƒ
Initialise (reset) the table columns before they are mechanically fixed
together.

The height-adjustable work benches E, 4 E and 4 E FIFO are already
initialised and ready for use when supplied.
Level the workbench by twisting the adjustable feet underneath the table
columns in or out by hand and check using a spirit level.
3. Operating data
Single column 1000 N
Table E 2 columns 2000 N distributed
Table 4 E / 4 E FIFO 4 columns 4000 N distributed
Perm. bending moment in travel mode 140 Nm
Speed 25 mm/s
Temperature range -5°C to +40°C
Noise emissions < 70 dB (A)
Travel range, Table E 680 mm – 1060 mm
Travel range, Table 4E 680 mm – 1100 mm
Threaded bores mounting plates 4 x M8x8
2 x M10x8
Storage temperature -25 °C to +70 °C
Relative humidity 5 % to 85 %
Air pressure > 84 kPa, equiv. to altitude of < 1400 m above sea level
In altitudes > 1400 m, the load values are reduced by 15%.
ƒ Maximum loading of overhang 200 N
ƒ
Selection and installation of the appropriate components ensures suitability
for use in areas where electrostatic charges pose significant hazards. We
recommend that you consult your item representative.