Italkero QUADRO 40, Руководство по установке и обслуживанию

Страница: 33 / 40

5
8
6
4
7 1
MAX
OFF
5
9
8
6
4
EIN
AUS
MANUAL MODE
The appliance is designed to work with the remote
control, but can also be controlled in manual mode by
acting on the gas valve.
Manual mode is recommended in the event of loss
of the remote control or during the extraordinary
maintenance phases by the Manufacturer's authorised
technical assistance.
The device in manual mode, requires some
operations to be performed on the valve,
before its use.
Switching on
- Open the gas supply valve.
- Turn on the valve unit by setting the switch (5) to “I”;
- Set the adjustment knob (1) to “OFF”;
- Turn the knob (7) to manual “MAN”;
- Disconnect the ignition cable from the rear connection
(9) and insert it into the faston (8);
- Insert a screwdriver into the hole (6) and keep the
magnet shank pressed;
- Press the piezoelectric power button (4), with the
magnet leg pressed, until the pilot flame is lit. Press and
hold the Magnet Leg for approximately 10 seconds, to
allow adequate heating of the Thermocouple;
- Remove the screwdriver, releasing the magnet shank;
- Turn the knob (7) to automatic “NO”;
- Turn the knob (1) from “OFF” to “MAx” as required.