Italkero Poster PE t1 30, Инструкция по установке и техническое руководство

Страница: 22 / 56

22
INSTALLATION
Chance B – inside tube assemblage
This system is used when the wall does not permit to
realize the proper work to install the tubes. To install
the tubes you need the spacing bar (1).
Before you start the work check that there is enough
space that permits the convector to do the right function.
Mark, execute space bar holes.
- Prepare the group adapter connection (as chan-
ce A2)
-- With Ø 32 mm tubes
- Assemblages the group adapter connection curves,
and fastens in position with the furnished screws.
- Remove the line graph insert the assembled group
and fasten on the template with the furnished
screws.
-- With Ø 54 mm tubes
- Disassemble the flange, exchange the stub pipes
with the curves, for the comburent air tube, and the
exhaust fume tube, fasten all assembling the flange.
- Remove the line graph, insert the assembled group
and fasten on the template with the furnished screws.
- Fasten to the wall the spacing bar support with the
furnished inserts.
- Complete the installation assembling it with the rest
of the tubes, fastening them to the wall with commer-
cial clamps.
Before you wall up the tubes, provide to
insulate the exhaust fume tubes, with strong
materials resistant at a greater temperature of
200 °C (ex.HT/-Armaflex).
Chance C – outside tube assemblage
This solution can be adapted when the exhaust fume
tubes and the comburent air intake tubes are to the
outside.
Before you wall up the tubes, provide to the
insulate the exhaust fume tubes, with strong
materials resistant at a 200°C temperature (ex.
HT/-Armaflex).
Group adapter connection tubes
- Insert in the wall the assembled group,
adapter
connection
tubes.
- Fasten the group,
adapter connection
to the tem-
plate with the furnished screws.
Complete the installation, assembling it with the rest of
the tubes, fastening them to the wall with commercial
clamps.
MIN
200
mm
B
1
C
MIN
200
mm