15
INSTALLER
PLACING DEVICE
This type of apparatus can be installed in an existing
chimney in which a new one constructed according to
the size of the desired pattern or the space available.
In both cases, the device can be installed (indoors or
outdoors) in two modes, depending on technical or
aesthetic:
A - placed in the furnace
B - built-in fireplace
A - placed in the furnace (indoors or outdoors)
In this case the device is simply supported and leve-
led horizontally, thanks to adjustable feet.
Once positioned, verify that the device is not
easily movable, so as to prevent an acciden-
tal release of gas supply pipe.
B - built-in fireplace (indoors or outdoors)
In this case the unit is recessed in the floor of the fire-
box and leveled horizontally, thanks to adjustable feet.
Connect the gas valve to the network with a
hose so as to allow the adjustment or the
possible replacement in case of failure. To access
the burner unit simply remove the top grille.
When installed in an existing chimney:
- Remove or open up, any dampers and orifice plates;
- Clean the chimney and test the smoke evacuation,
before installing the device.
COMPARTMENT HOUSING
The choice depends on the Device is the space avai-
lable to the aesthetic taste of the purchaser.
Recommendations
- Verify the correct size according to the size and
characteristics of the environment.
- Check the chimney: MIN 18cm of diameter and
tube vertical length MIN 2m.
- Veificare the correct dimensions of the front of the
fireplace from the device chosen:
--- The height (1) between the upper surface of the
Device and the beginning of the hood 50cm chimney
must be MAX.
Do not exceed these limits to facilitate the
exit of smoke through the hood, preventing
splashing in the installation.
--- Width (2) MIN corresponds exactly to the required
width of the outer frame (5) of the Device.
--- Length (3) MIN corresponds exactly to the length
required of the outer frame (5) of the Device.
- The height (4) MIN required between the device
and the floor of the firebox, depends on the type of
installation (resting or embedded).
