23
Earthcore Industries
MAGNUM
Series Fireplace
23
6.
The fireplaces come with an eight inch (8”) thick
damper beam assembly, an eight (8) piece component
group that is to be assembled on top of the firebox
sidewalls and backwall.
The damper beam assembly consists of six (6) long
lintel pieces and two (2) short damper beam side pieces.
The damper side pieces are designed to sit on the
firebox side wall between the front lintel and the back
lintel. Each of the damper side pieces is designed
specifically for its own side of the unit. When properly
set, each damper side piece fits flush with the outside
face of the firebox sidewall so that its interior bottom
edge aligns with the interior angle of the firebox side wall
that it sits on.
(Figure 20)
The six (6) lintels when they are put together they
will be equal to the width of the fireplace model that they
serve. Properly placed, the lintel is to sit on top of the
firebox back wall and flush with it; the other lintel sits
flush with the front of the firebox, spanning the firebox
opening. These components both sit on their narrow
base so that their beveled face points down and into the
firebox interior.
(Figure 20)
Be sure to Earthcore adhesive all damper beam
components to the top surfaces of the firebox. Earthcore
adhesive the contact surfaces of each damper side
component where it meets the front and back damper
beam lintel components.
NOTE:
The MAGNUM Fireplace will require in-line or
chimney top dampers. The dampers are not included with
the firebox.
Assembly Instructions - MAGNUM
Part #M94L
FIGURE 20
Damper Beams:
84": Part# 74, 167, 75
96": Part# 74, 168, 75
108": Part# 83, 168, 84
120": Part# 83, 170, 84
