3 - 21
1
Use / Range of application
iSH
AN
centralized lubricating systems are designed to lubricate ball bearings, flat
bearings, flat slideways, circular slideways, linear guides, cams, gears, chains, etc..
iSH
AN
centralized lubricating systems are suitable for the lubrication of various
machines, such as lathes, mills, presses, planner, grinder, etc. It is possible to control
different lubricating points at different machines at the same time.
The permissible oil viscosity of
YET-A lubricator
s range from 30 cSt to 250 cSt.
The YET-A lubricators are designed to lubricate intermittent. Its’ control unit may be
used as timer for time-dependent control or as counter for load-dependent control. The
interval times may be optionally adjusted from one to 999 minute for time-dependent
control, or from one to 999 pulses for load-dependent control. The lubrication time is time
dependent control, and ranges from one to 999 seconds. There are two control modes when
actuation: the lubricating actuation mode - to pump oil as soon as power on , or the
recording actuation mode - to continue the state recorded before last power off.
The maximum discharge rate of YET-A1 pump is 200 ml/min, and 100 ml/min for
YET-A2 model. The max discharge pressure are 7 bar for YET-A1 model, and 15 bar for
YET-A2 model. In order to protect the auxiliary equipments, there consists a pressure
release valve to control the pipe pressure remains a constant value during lubrication times.
For safety measurements, the oil level switch could send an acoustic alarm through
buzzer and stop pumping oil. Also, the pressure switch is optional for customer, it can detect
whether the oil pipe system leaks. To get further safety measurement, it is possible to
connect the lubricator to other controller, computer properly to enhance the alarm system.
