Iseki 1812001, Руководство пользователя

Страница: 11 / 31

11
546336.B.9
Original version
ENGLISH
Replacing Belt
Drive belt must be replaced by an authorised dealer.
When the belt appear damage or skid, please make adjustment or replacement as follows,
1. Turn off engine and allow the machine to cool down.
2. Loose the fixed bolt of belt guard, remove the belt cover.
3. Loose the fixed bolt on the engine and rotate the hand wheel toward right or left to adjust or remove belt.
4. Lock the fixed bolt of engine, fold the folding hand of hand wheel, and refit the belt.
Blade Housing Blocked
1. Stop the machine and remove the spark plug wire.
2. Remove the Inlet chute and the cap of bearing (Reverse of Step 3 in Assembly).
3. Turn the shaft of roller by the right with a spanner in the toolkit to clear the blocked material.
Warning
Don’t touch the blade during this working; make sure your hands do not get cut by the blades.
Iseki Chipper Blade Adjustment
Step 1: Disconnect the spark plug lead to ensure motor will not
start.
Step 2: Make sure all electrical connections are disconnected on
the inlet chute.
Step 3: Remove the 2 bolts holding the chute to the main frame.
Step 4: Slide the chute off the main body. (2 people must be used)
Step 5: Rotate drum by hand to align the cutter on the drum with
the edge of the cutter blade, being careful not to get body parts
caught between blade and cutter.
Step 6: Loosen all blade screws using a 6mm allen key. Then
nip up the 2 end screws so that the bar can be adjusted by light
tapping.
Step 7: Insert a 1.5mm to 2mm feeler gauge between the cutter
and blade, slightly rotating back and forward to get the correct gap.
Step 8: Tighten the 2 end screws and recheck gap. If ok then
tighten the remaining screws.
Installing the chute is the reverse of the removal procedure.